mgs
[Top] [All Lists]

RE: Off Topic, again...

To: "MGs (E-mail)" <mgs@Autox.Team.Net>
Subject: RE: Off Topic, again...
From: Phil Vanner <pvanner@pclink.com>
Date: Fri, 21 Nov 1997 12:14:24 -0600
I've always been assuming that the spinning produced a gyroscopic stabilizing 
effect at high vehicle speeds. Have I been wrong?

Phil Vanner
'61 Midget (with captain's chairs for simultaneous rotation along two axes)

-----Original Message-----

As, however, we spend most of the time "topless" the resulting injuries 
in top on spinning are irrelevant. The best way we havce found to offset 
the size diff is to utilize the bonnet as an effective support. However 
this is predicated on the MG in question being immobile and therefore 
does no effect the lateral motion at high speeds.

Larry Macy
78 Midget

>Correct you are, Bob, although probably not in a Midget, unless the doors
>were open for the intertial lateral stability supplied by the extended
>mass
Snippage
.  This usually  happens only after sustained high
>speeds and, fortunately, is not always obtainable.
>
>Larry Dickstein
>bugide@juno.com
>
>
>On Fri, 21 Nov 1997 08:56:55 -0600 Robert Allen <boballen@sky.net>
>writes: 
>>I daydreamed through most of my science classes but I seemed to 
>>remember a concept where, if you could mount the smaller unit from a
>central pivot point and then spin it around on this new axis, the
>gyroscopic effect could have a profound impact on the larger mass. 




<Prev in Thread] Current Thread [Next in Thread>