Try http://freespace.virgin.net/paul.hunt1/ and select 'Spanners' and 'Front
Hubs'.
PaulH.
-----Original Message-----
From: Calvin Krug <ckrug@laf.cioe.com>
To: mgs@autox.team.net <mgs@autox.team.net>
Date: 31 May 1999 03:40
Subject: wheel bearing shims
>In the near future, I will be replacing the front wheel bearings on my wire
>wheel B, and I've been looking for information on getting them shimmed
>properly. All that my Haynes manual says is that the endfloat of the
>bearings must be correct, but doesn't tell me how to check it. (Typical
>for those books) Is there a webpage somewhere that has instructions for
>this? Thanks in advance.
>
>Calvin Krug
>
>
>
|