Yup.
Pace Setter header (same manuf. as Monza) Normally come with a slip
joint. Someone has welded on a 3 bolt flange assy.
Kelvin.
> -----Original Message-----
> From: wizardz [mailto:wizardz@maxinter.net]
> Sent: Friday, September 24, 1999 11:39 AM
> To: Michael Graziano; 'Spridgets'; MGList (E-mail)
> Subject: Re: 1500 header brand?
>
>
> looks like an old Monza system...
> but I'm not sure about the output flange style
>
> Paul Tegler
> 1973 BGT - Daily Driver
> Rat - 1980 Spitfire w/ O/D - in re-hab
> Punkin' - 1978 Spitfire - in Superb Shape!
> email: wizardz@toad.net http://www.teglerizer.com
>
>
> -----Original Message-----
> From: Michael Graziano <mgrazian@ltcm.com>
> To: 'Spridgets' <spridgets@autox.team.net>; MGList (E-mail)
> <mgs@autox.team.net>
> Date: Friday, September 24, 1999 2:06 PM
> Subject: 1500 header brand?
>
>
> Hey folks. Someone asked me an interesting question. I have
> no idea what
> brand this header is. Neither did the seller (it was on a
> parts car). Can
> anyone venture a guess? THere's some heat discoloration on
> the tubes, but
> no rust anywhere but on a weld at the bottom (where the 4
> tubes lead into
> one), and only a little.
>
http://mgraziano.bizland.com/midgetheader.jpg
Mike
__/__,_
_____(_o___o_)_______________________
/ \
| Michael Graziano |
| Long Term Capital Management L.P. |
| Phone: 203-552-5706 |
| Fax: 203-552-5869 |
| Email: mgrazian@ltcm.com |
\_____________________________________/
|
