At our last club meeting a couple of the guys mentioned that they needed to
do some engine work because of low compression or excessive oil leakage. My
loving wife readily volunteered me and our garage for an engine rebuild
session. Of course the others jumped on the idea, so it looks like right
after the New Year we are going to be rebuilding 3 MGB engines in my garage.
I've done 3 MG engines, as well as a few others, with pretty good success.
I'm going to talk to a local machine shop to see if we can get some kind of
club/quantity discount for the required machine work. I plan to have the
heads done completely, checked for cracks, surfaced (if needed) and valve
job. We will also have the blocks cleaned, surfaced (if needed) and new cam
shaft bearings installed.
I intend to replace the front transmission seals, but any other advise of
things we should do while we have the engines out would be appreciated.
Thanks,
Ken
[demime 0.97c removed an attachment of type application/ms-tnef which had a
name of winmail.dat]
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|