Hi again list: I am reassembling the driveline on my '74 B. The Haynes manual
says"when reassembling the propeller shaft, it is essential to ensure that
the yoke A is in alignment with yoke B".
That makes sense, they even have a drawing.
However, it also says to line up the arrows on the sleeve assembly with the
arrows on the splined portion of the shaft.
If I do the "arrows", the yokes are 90 degrees OUT of the alingment as
required by Haynes.
If I align the yokes, as mentioned, the arrows are out 90 degrees..
Who's on first here and what is more important.
Thanks
Dennis Barr
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|