I have finally striped my B to the bone and want to put the body shell
on a dolly similar to the one seen at the bottom of this page,
http://www.classicshowcase.com/63mg_b_grn_949.htm; yes I know this is
the $25K MGB ($30K on their website). But the point is, I want to make
that dolly and would like some plans or list of parts I need to put this
together. Also, is there any problem with flipping the body shell
upside down to clean and repair the bottom? Any special bracing I need
to do before hand? And are there any other diagonal body measurements
than the Vertical and Horizontal Alignment Checks in the Bentley
Workshop Manual?
Matthew Hale
67 B
http://projectmgb.phathookups.com
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|