mgs
[Top] [All Lists]

Re: jumpy tach

To: MG List <mgs@autox.team.net>
Subject: Re: jumpy tach
From: Max Heim <mvheim@studiolimage.com>
Date: Thu, 08 Apr 2004 13:43:44 -0700
This may not have any bearing on your problem, but I was having similar
symptoms a while ago. When I replaced my battery (not for this reason), the
tach started behaving normally again. I thought it might be a voltage issue.

In my case I have an optical sensor, so no points were involved.

on 4/8/04 12:24 PM, bilking@comcast.net at bilking@comcast.net wrote:

> My electronic tach has become jumpy and slow to respond, it does not go above
> ~2500rpm.  I recently changed the points and condensor and cannot remember if
> the tach problem began at this time.  Dwell was set with a meter and timing is
> correct.  Is the tach going south or could the points be the cause?
> 
> 
> Bill


--

Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires





<Prev in Thread] Current Thread [Next in Thread>