mgs
[Top] [All Lists]

Re: Helping seat foam a bit?

To: "Tim Holt" <holtt@nacse.org>, "MG List" <mgs@autox.team.net>
Subject: Re: Helping seat foam a bit?
From: "Paul Hunt" <paul.hunt1@blueyonder.co.uk>
Date: Wed, 9 Feb 2005 09:10:07 -0000
If the top of the existing foam is sculptured then I'd put additional sheets
underneath, where they are less likely to ruck up anyway.  Certainly current
MGB replacement foams seem way too high or too dense so I'd keep the
existing ones as long as you can, as one usually needs to cut an inch or so
*off* the new ones.

PaulH.

----- Original Message -----
From: "Tim Holt" <holtt@nacse.org>
To: "MG List" <mgs@autox.team.net>
Sent: Tuesday, February 08, 2005 7:04 PM
Subject: Helping seat foam a bit?


> So, lay a few layers of 1/2" foam over the top to build it up?  Or
> should I put a piece underneath between the diaphragm and the foam?




<Prev in Thread] Current Thread [Next in Thread>