Hello friends,
Found a little time this afternoon to reassemble
the left front axle and hub. If you have followed my
notes you may remember this 'before' picture
http://www.aubard.us/MGB/HPIM0653.JPG . Here's how it
looked right before reinstalling the hub and new rotor
http://www.aubard.us/MGB/HPIM0685.JPG .
The hub and new rotor were mated and the rear wheel
bearings and grease seal were installed
http://www.aubard.us/MGB/HPIM0686.JPG . Here's a
close-up of the bearing and seal
http://www.aubard.us/MGB/HPIM0687.JPG .
The grease cap was installed after installing the
shims, outer wheel bearing, lock-washer and nut -
torqued to 45+ lb-ft
http://www.aubard.us/MGB/HPIM0691.JPG .
Here's how the final solution looks, without
brakes, http://www.aubard.us/MGB/HPIM0690.JPG .
Once the rebuild kits arrive I will reassemble the
pistons to the caliper and brake assembly will begin.
Happy Sunday afternoon.
rick
'70 MGB Tourer
'79 Ferrari 308GTB
PS: In case any of you are bored and have a few hours
of extra time, here a link to the pictures of my
308GTB's restoration - still a little bit in progress
http://www.aubard.us/Ferrari/ .
_______________________________________________
Edit your replies
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
|
