Thanks, Peter. That information helps a lot. I'll send it on.
Howard
----- Original Message -----
From: "Peter C" <peter@nosimport.com>
To: "Howard Battan" <battanhr@comcast.net>; "MG List" <mgs@autox.team.net>
Sent: Tuesday, February 19, 2008 7:25 AM
Subject: Re: [Mgs] MGA master cylinder bore size - a little OT
> Howard, I have the Lockheed catalogue of the period. A 55 Oxford Series II
> and an MGA use the same master cylinder assembly part number 39121.
>
> BTW, the Magnette cylinder is essentially the same with the minor detail
> that the brake and clutch bores are reversed! Reason to be cautious. That
> check valve in the wrong bore can be "pesky". The MGA pedal pivot is below
> the master and the bores face away from the driver. The Magnette pedal
> pivot is above the master and the bores face the driver.
>
> Peter C.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|