Thanks to those who have replied. I had Googled the subject but still have
not found anything of the mystery mark: S...
----- Original Message -----
From: "Eric" <eric@erickson.on.net>
To: "MG List" <mgs@autox.team.net>
Sent: Saturday, November 15, 2008 1:14 AM
Subject: Re: [Mgs] head question
> On 15/11/2008, at 12:53 PM, Malcolm Jeffcock wrote:
>> The head from the "donor engine" a 3 bearing older engine has a
>> marking on the under side sort where the thermostat bulge is
>> located. It has an "S" in a raised letter in the same fashion as the
>> MOWOG lettering.
>
> I am sure you can use Google as well as I can, but I noticed I had
> this page bookmarked:
>
> Identifying MGB Cylinder Heads
>
> http://www.flowspeed.com/cylinder-ident.htm
>
>
>
>
> Eric
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
>
> You are subscribed as msjeffcock@eastlink.ca
>
>
> Mgs@autox.team.net
> http://autox.team.net/mailman/listinfo/mgs
>
> http://www.team.net/archive
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.9.4/1789 - Release Date: 11/14/2008
7:32 PM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|