[Mgs] Piston thurst

[otis15@aol.com]

When I removed the pistons from a 1973 18v the compression ring gaps were on
the cam side of the pistons. Reading the Haynes manual it says the compression
rings should be set at 90 degree gap opposite the thrust side of the piston,
that would set them opposide side of the cam since the engine turns clockwise.
Am I correct?

                                                    Thank for any help
                                                                             
                    Steve
_______________________________________________

Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums