mgs
[Top] [All Lists]

Re: [Mgs] Front Wheel bearings 70B

To: Max Heim <max_heim@sbcglobal.net>,MG List <mgs@autox.team.net>
Subject: Re: [Mgs] Front Wheel bearings 70B
From: Barrie Robinson <barrie@look.ca>
Date: Mon, 30 Aug 2010 20:16:09 -0400
I got new splines for my MGB wire wheels and they were fine - not inferior,


At 07:42 PM 8/30/2010, Max Heim wrote:
>I was thinking wire wheel hubs, I admit. The "new" ones are generally
>considered inferior, so it could be worth salvaging an original with good
>splines. Junkyard hubs, if you can find them, are unlikely to have usable
>splines.
>
>
>--
>
>Max Heim
>'66 MGB GHN3L76149
>If you're near Mountain View, CA,
>it's the primer red one with chrome wires
>
>
>on 8/30/10 3:47 PM, Councill, David at dcouncill@msubillings.edu wrote:
>
> > I sure hope we are not that desperate for a hub. I would hope that there
> > are still plenty of good used hubs out there. I just replaced the front
> > hubs on my 64B, converting from wire wheels to disc wheels to match the
> > rear axle wheels. It was fairly straight forward but I had to obtain one
> > front hub since I could only find one spare (from my 71BGT) amongst my
> > growing collection of used parts. I got one from a Canadian salvage
> > which also included the bearings, spacer, shims, washer and nut, all for
> > $45 including shipping. A couple US salvage yards also offered to sell
> > me one, at prices ranging from $50-$75. Wire wheel hubs will likely be a
> > bit more expensive and run a chance of worn splines but new ones are
> > available from Moss for about $120.
> >
> > David Councill
> > 64 B
> > 67 BGT
> > 72 B
> >
> > -----Original Message-----
> > From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net] On
> > Behalf Of Max Heim
> > Sent: Monday, August 30, 2010 4:06 PM
> > To: MG List
> > Subject: Re: [Mgs] Front Wheel bearings 70B
> >
> > It is at least conceivably possible that your machine shop could repair
> > this hub by adding a bead of weld then lathing it to the correct inside
> > diameter and pressing the new race. I suggest this since I know quality
> > hubs can be hard to find.
> >
> >
> > --
> >
> > Max Heim
> > '66 MGB GHN3L76149
> > If you're near Mountain View, CA,
> > it's the primer red one with chrome wires
>_______________________________________________
>
>Mgs@autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation  $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe: http://autox.team.net/mailman/options/mgs/barrie@look.ca

Regards

Barrie
(705) 721-9060 
_______________________________________________

Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>