Or one of those pipe repair joints that is rubber and has hose clamps on
both ends.
Chad Cooper
'72 B Roadster
Allen, TX
-----Original Message-----
From: mgs-bounces@autox.team.net [mailto:mgs-bounces@autox.team.net] On
Behalf Of Max Heim
Sent: Wednesday, March 21, 2012 5:13 PM
To: MG List
Subject: Re: [Mgs] Aluminum bonding agent
I was thinking the same thing. Did you consider a rubber grommet?
--
Max Heim
'66 MGB GHN3L76149
If you're near Menlo Park, CA,
it's the primer red one with chrome wires
on 3/21/12 2:40 PM, Richard Ewald at richard.ewald@gmail.com wrote:
> JB weld leaps to mind, but I think you might have a huge problem
> trying to use anything to bond a filler neck to a tank. The filler
> neck will act as a long lever, and any movement at the end of filler
> neck will quite likely crack any bonding agent at the lower end.
> Good luck
> Rick
>
> On Wed, Mar 21, 2012 at 12:49 PM, davewillner <davewillner@pa.net> wrote:
>
>> I need some advice on the availability of a very high strength
>> aluminum bonding agent, that can be used on a gas tank, to bond the
>> filler neck (long story...). Does anyone know of an industrial
>> bonding product that is somewhat easy to use that will make a strong,
>> permanent bonding seal? Thanks
>>
>> Dave Willner
>> Stroudsburg PA
>> 59 TR3A
>> 70 MGB
>> 70 BSA 441 VS
_______________________________________________
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net
|