Re: [Mgs] valve adjustment

["Paul Hunt" <paul.hunt1@blueyonder.co.uk>]

It shouldn't need to be as accurate as that.  The base circle *should* exist 
for a minimum of 180 degrees at the heel, and probably slightly more than 
that.  Which means that anywhere in that 180 degrees *should* give the same, 
maximum clearance.  But as individual cams will show, the greatest clearance 
can exist over a much smaller rotational angle than that, and in any 
position.  It's that you need to find, on your cam, and adjust to.

http://www.lunatipower.com/Images/Tech/Cams/AnnotatedCamLobeLarge.gif

PaulH.

----- Original Message ----- 
> The crane cams method just about guarantees that the lifter for
> the valve you are adjusting is resting on the base circle:
_______________________________________________

Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: 
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net