If the valve train is working OK, it may be running on only the front
carb. I've run into this.
CR
On 1/28/2013 1:40 PM, Bill Snyder wrote:
> I have a '66B that I cranked after a 6-month hiatus a few days ago. It
> started but ran very rough as if on 3 cylinders. I put in fresh plugs,
> checked the dizzy cap and cleaned it contacts as well as the rotor. There
> was no change. After re-inspecting the plugs, it appears that the 4th
> cylinder was not firing, but the plug was not gas or oil fouled. Laying the
> plug out on the block, attached to the plug wire and cranking showed the
> plug firing properly, so I am apparently getting no fuel to that cylinder.
> Can anyone run me through the procedure to check on that issue? It has
> Petronix ignition and has been converted to negative ground. Thanks in
> advance.
>
> Bill Snyder
>
> Waynesville, NC
> _______________________________________________
>
> Mgs@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/mgs/ccrobins@ktc.com
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|