mgs
[Top] [All Lists]

Re: [Mgs] BGT Resurrected

To: daybell7@aol.com
Subject: Re: [Mgs] BGT Resurrected
From: "mgbob@juno.com" <mgbob@juno.com>
Date: Sat, 20 Dec 2014 20:36:42 GMT
Cc: mgs@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: mgs@autox.team.net
Full-name: "mgbob@juno.com" <mgbob@juno.com>
Hi Steve,  Keep us posted on the improvements you make.  Clutch judder can be
internal, but an obstruction in the slave-cylinder hose can cause slow,
erratic release, sometimes judder.   Less frequent with MGBs than T-series
cars, though still possible, clutch judder because the rear axle U-bolts are
loose.   That's a quick & easy check to perform.Bob
---------- Original Message ----------
From: daybell7@aol.com
To: mgs@autox.team.net
Subject: [Mgs] BGT Resurrected
Date: Sat, 20 Dec 2014 15:31:07 -0500

Thanks for the replies.  All I want to do is drive the car for fun running
errands, etc.  I figure the more reliable, the more I'll use it for
transportation. I got new valves because number two & three cylinders had
weak
compression and the car backfired terribly. I suspected the valves needed
adjusted after so many (albeit not very many) miles, plus I had this miss or
sporadic cut-out of the engine.  The speedo reads 30k.  It has headers, later
model seats and the weber, so anything could have happened to the car in the
past.  The carb appeared to be requiring attention, so I cleaned it and
installed a K&N air filter.  The single carb mixture screws didn't seem too
difficult, either.  The car is solid and roadworthy.  The distributor is not
is the best condition, but I do have a Mallory Unilite that came with the
car.
I understand that Lucas additives are beneficial to an engine's health and is
thicker than 20-50, so oil pressure could improve, plus internal parts
(rings,
lifters, con-rods, bearings, etc.) might unstick and perform better. I
appreciate very much thoughts on this.  I intend to run it for some time and
adjust, test, and see how much I can tolerate before doing more complicated
work on the bearings, rings, etc.  I was having fun the way it was, simple
improvements will make me (& wife) happier rather than time consuming and
costly refinements. One thing I didn't mention initially was the clutch has a
fairly drastic shudder.  I have to keep RPMs up to avoid the shudder.  I
intend to bleed the slave cylinder to maybe help this.

Thanks again, Steve H.
'73 TR6
'72 MGB
'59 Morris Minor
'68 BGT
_______________________________________________

Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mgbob@juno.com
_______________________________________________

Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>