| To: | <mgs@autox.team.net>, <guinness@stclegal.com> |
|---|---|
| Subject: | Re: [Mgs] MGA Master Cylinder rebuild |
| From: | Eric J Russell via Mgs <mgs@autox.team.net> |
| Date: | Mon, 4 May 2015 20:46:02 -0400 |
| Authentication-results: | smtp03.agate.dfw.synacor.com smtp.user=ejrussell@mebtel.net; auth=pass (LOGIN) |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | mgs@autox.team.net |
| References: | <mailman.1.1430762401.9061.mgs@autox.team.net> |
| X_cmae_category: | , , a=8nJEP1OIZ-IA:10 a=xwPayol1AAAA:8 a=zo8hvysWAAAA:8 a=0c3b9xJUxCKO4cTypx4A:9 a=wPNLvfGTeEIA:10 a=v__-Zx12KBsA:10 a=DAcbntRjZGkA:10 a=kEzvJGxzP0oA:10 a=hSXvhAbUaY0A:10 a=I0wsP0/ub+0M/VQyKFHlEA==:117 |
> I am having a heck of a time getting the primary piston cup onto the > master cylinder piston on my MGA 1600 A few issues to consider. Are you sure the internal parts are original? 'Back-in-the-day' there were rebuild kits that used non-standard parts. And the rubber seals currently available may not even fit original pistons properly. See: Master Cylinder Seals Too Big http://www.mgaguru.com/mgtech/faulty/ft053.htm Master Cylinder Fault http://www.mgaguru.com/mgtech/brakes/bt101b.htm And: Rubber Seal Variations http://www.mgaguru.com/mgtech/hydraulics/ht113.htm Eric Russell Mebane, NC _______________________________________________ Mgs@autox.team.net Archive: http://www.team.net/archive Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Mgs] Gunson Eezibleed for the MGA, Gordie Bird via Mgs |
|---|---|
| Next by Date: | [Mgs] MGB rear cylinder circlips, PaulHunt73 via Mgs |
| Previous by Thread: | Re: [Mgs] MGA Master Cylinder rebuild, mgbob--- via Mgs |
| Next by Thread: | [Mgs] Gunson Eezibleed for the MGA, Robert J. Guinness via Mgs |
| Indexes: | [Date] [Thread] [Top] [All Lists] |