[Top] [All Lists]

Re: [Mgs] Differential drain plug tool

To: <>
Subject: Re: [Mgs] Differential drain plug tool
From: PaulHunt73 via Mgs <>
Date: Mon, 6 May 2019 08:23:27 +0100 uoiGa3GSCvmSiOMKbRmszJwfKnthUebi0072t6bgCRhWwsqz4hv1nDuc
References: <> <>
I just used a old large bolt cut down and tapered.  Gave me low-profile head 
for a socket spanner for use on the level plug where space is restricted. 
The hole for the tool may be square but it isn't parallel-sided. If it were 
you could use a 1/2" socket wrench without a socket - which I did for a 
while but it tends to slip out.  Best of all is to replace them with the new 
plugs which take a hex Allen key.


----- Original Message ----- 

More than one way to skin a cat.  I got a
standard 3/8 to 1/2 drive adapter for $1 from a
cheap tool vendor.  Grrind the output end to a
little taper, and it's a perfect fit.




<Prev in Thread] Current Thread [Next in Thread>