Axles are all above the frame rails, gents. Think of the arch in the
frame that would be required if axles were below the frame - major
re-engineering here a la Detroit. Not Morganesque.
Bob Alexander
On Tue, 28 Oct 1997 LanceKL@aol.com wrote:
> Date: Tue, 28 Oct 1997 18:12:47 -0500 (EST)
> From: LanceKL@aol.com
> To: zehrinwa@UMDNJ.EDU, morgans@Autox.Team.Net
> Subject: Re: low riders
>
> In a message dated 97-10-28 17:41:34 EST, zehrinwa@UMDNJ.EDU writes:
>
> << In regards to Joe DeLuca's comments in the 4/4 vrs. +4 issue: correct me
> if
> I'm wrong but... The lower stance of the 4/4 is due, in part, to the
> placement of the rear axle ABOVE the frame rails (allowed, I gather from
> Joe, because the ford mill is shorter than the TR mill). Is this true? Is
> the rear axle on the typical +4 located underneath the frame rails? I >>
>
> I have never seen a morgan with the rear axle below the frame rails.
>
> Lance K. Lipscomb
> 81 Plus 8 - axle definately above the frame rails.
>
|