Fellow moggers,
I am looking at my top frame and trying to attach it to the new wooden
tub of my 1963 Morgan.
I find the two holes bracket that the top is attached to on a pivoting
bolt,
and am not sure where to place it , there is a series of 4 offset screws
at a joint where it should go, but they dont seem substantial enough to
handle the torque, and I am pretty darn sure they dont bolt through as
the bevel hole is on the inside and a bolt would not be the outside,
so it a plate used in addition to help or am I way off?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/morgans
|