OK, thanks. I was thinking the five bolts around the adaptor would do it, but
it didn't and thought I had better ask before going any farther.
All the best,
Bill
Sent from my iPhone
On Jul 1, 2013, at 9:56 AM, Stephen D Stierman <morgan7709@sbcglobal.net>
wrote:
> Assuming this is a standard wire wheel hub, the nut in the middle of the
spindle would be all you would need to take off plus a brake caliper if disc
brakes are used. The rotor or drum will slide off the spindle.
> Steve
>
> From: "wbeech@flash.net" <wbeech@flash.net>
> To: morgans@autox.team.net
> Sent: Monday, July 1, 2013 9:35 AM
> Subject: Re: [Morgans] 4/4 Spindle
>
> The threads are bad on one of my front wire wheel adaptors, am I correct
in
> seeing that the entire rotor and spindle has to be removed to remove the
> adaptor?
>
> Thanks,
> Bill
> _______________________________________________
>
> Morgans@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/morgans/morgan7709@sbcglobal.net
_______________________________________________
Morgans@autox.team.net
Archive: http://www.team.net/archive
|