nobbc
[Top] [All Lists]

Re: [Nobbc] Lotus owners with webers

To: North Bay British Car Club <nobbc@autox.team.net>
Subject: Re: [Nobbc] Lotus owners with webers
From: Tony Korman <tonykorman@sbcglobal.net>
Date: Mon, 22 Feb 2010 19:41:05 -0600
Can whoever did it do Strombergs

Sent from my iPhone

On Feb 21, 2010, at 12:53 AM, Sarto Rocheleau <sarto477@yahoo.com>  
wrote:

> Hello All---
> I want to make an announcement that as of today, I now have  
> perfectly tuned
> 151 webers. No bucking, no flat spots, smooth at idle to wide open.  
> It pulls,
> in all gears, like it had 15 more HP. and when it hit 4,500 rpm it  
> had a surge
> of new power. Hard to believe, an old friend, Keith Franck, after  
> years of
> research, has re-engineered the E-tubes and hypojets to perfection.  
> What he
> has done to webers is quite scientific and over my head so I copied  
> a post
> below of some of the details from Keith's site.
> Sarto
>
>> Re: Sarto's Tuneup
>> He already had my experimental e-tubes that were 8.35mm in diameter  
>> so the
> impedance is okay. Next we found the front carb had the fuel level  
> set too
> high by 1mm so we lowered it back down to 25mm. The first set of  
> hypojets to
> get installed were .020" ones and when the rpms was elevated using  
> the idle
> speed screw it got hung at about 2000rpms and it was spitting,  
> that's a dead
> giveaway clue it's too lean! The stock idlejets were 45 something so  
> next we
> stuck in .026" hypojets. That did the trick, it immediately revved  
> up and down
> like a sewing machine. Went for a test drive and it runs absolutely
> flawlessly. The only issue to resolve is whether or not it needs  
> apertures in
> the first progressive holes because it did exhibit symptoms of  
> having a lazy
> idle. Sarto installed a set of temporary apertures and just drove  
> off to test
> if those will in fact make the slight lazy idle symptom go away.  
> Depending on
> how that goes will determine if we need to glue in
> the permanent apertures or not.
>> -Keith Franck
>>
> He did not need the apertures after all, reducing the idle speed a  
> tad is all
> it took to stop the lazy idle symptom. Gave him some of the 1mm and  
> 2mm
> spacers to elevate the e-tubes to test later on. He left to go over  
> to Mike
> Ostrov's to have Mike see the results firsthand. It runs like sewing  
> machine
> is the best way I can describe it but also hauls ass when you want  
> too.
>
> We did the tuning without using an AFM. Only tuned it at this  
> juncture to get
> the tractability perfect. I might be able to improve the fuel  
> mileage a bit
> more but he needs to drive it to determine what it's getting now.
> -Keith
> One thing that is becoming obvious to me is the 151 carb responds to  
> my
> jetting in a spectacular fashion. The improvement is pronounced  
> enough that
> I'm seriously considering shelving my original 18s and go buy some  
> new 151s
> with three progressive holes. I have no idea why this is the case  
> but it's for
> real.
> -Keith Franck
> Mike Ostrov drove my Elan and confirmed that it runs like no other  
> Elan with
> webers.
> A new day for webers
> Sarto
> _________________
> lotus elan 1966 S3 FHC
> 36/5785
> LHD
> _______________________________________________
> Nobbc mailing list
> Nobbc@autox.team.net
> http://autox.team.net/mailman/listinfo/nobbc
_______________________________________________
Nobbc mailing list
Nobbc@autox.team.net
http://autox.team.net/mailman/listinfo/nobbc

<Prev in Thread] Current Thread [Next in Thread>