Have you tried McMaster-Carr? They have a n online catalog.
http://www.mcmaster.com/
Look under machine screws. The ones I always thought looked closest were
called fillister
Good Luck,
Bill Schickling
-----Original Message-----
From: owner-oletrucks@autox.team.net
[mailto:owner-oletrucks@autox.team.net]On Behalf Of Mark Treutelaar
Sent: Sunday, October 09, 2005 12:40 PM
To: old trucks
Subject: [oletrucks] Problems finding screw
Hi I have a 235 engine with the original 1BL carbereator . The problem I
have
is that I need to mount the choke and throttle cable clamp to it . I need
longer screws for the carb because after I put the 2 clamps on the screws
are
no longer long enough. Im pulling my hair out trying to locate screws like
this with a fine thread . These are the screws that mount the 2 halfs of the
carbereator together . Any ideas where I could purchase thes screws would
be
appreciatted . Ive checked NAPA and hardware stoires with no luck
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|