Re: *big* tools

[dave.williams@chaos.lrk.ar.us (Dave Williams)]

-> flatbed that brought it to our house. We then moved it to the back of
-> the garage by putting some steel tubing on the floor and rolling the
-> mill across

 Yep, that seems to be the standard method.  However, my Gorton mill
isn't flat on the bottom.  It has little cast-in feet at the corners,
about an inch high, perfect for lousing up easy rolling.  I had thought
about jacking it up and bolting some angle iron or something under
there, but it was easier just to rent the pallet jack.