shop-talk
[Top] [All Lists]

Hydraulic Press

To: "'shop-talk@autox.team.net'" <shop-talk@Autox.Team.Net>
Subject: Hydraulic Press
From: Lyn Fatt Brian <Brian.LynFatt@TRAVEL.eds.com>
Date: Fri, 30 Oct 1998 11:03:26 -0500
>From:  Gil Fuqua [SMTP:gfuqua@corpcomminc.com]
>Sent:  Thursday, October 29, 1998 2:32 PM
>To:    shop-talk@Autox.Team.Net
>Subject:       Hydraulic Press
>
>
>I am looking at adding a hydraulic press in my shop.  It will be used
>primarily for removal/insertion of bearings.  I want one large enough
to
>remove the wheel bearings on my 19" and 21" wheels (antique cars).
>
>What is your experience with hydraulic presses? Recommendations on
20-ton,
>40-ton? And, where's the best place to buy one?

I bought one of the 20 ton presses from
Harbor Freight. It works fine. You will
need other accessories to help with pressing
out stuff. (Like strong enough pieces of iron
to hold the bearing separator.) Only other
annoyance is that the 20 ton press is too
short for me. (I'm 5'8")  I look over the top
bar when it is setup.  The unit is also heavy.
I get a workout every time I set it up. The 
bottle jack itself is about 20 pounds or more
and it makes an ear ringing bang when you slip
and drop it. :)

The 40 ton that a friend has is much nicer 
unit and it has the slow and fast levers for 
movement of the jack. The slow movement lever 
doesn't cause the bearings to let go with 
another ear ringing bang like the 20 ton unit 
does. The table is also wider to fit things 
like front wheel drive hubs. You'll probably 
need a forklift to move the unit though. Just 
moving the table to a different height makes 
one invent new swear words. :) 

Regards,
Brian
email--brian.lynfatt@travel.eds.com

<Prev in Thread] Current Thread [Next in Thread>