I got mine from Mcmaster-Carr. Look at
www.mcmaster.com and search for left-hand jobbers drill.
Mark Miller
measure once, curse twice
> ----------
> From: Lee Daniels[SMTP:DANIELS@alchem.chem.tamu.edu]
> Reply To: Lee Daniels
> Sent: Saturday, May 15, 1999 10:09 AM
> To: shop-talk@autox.team.net
> Subject: Drill bits, list (was: E-Z out)
>
>
> >The tool you are looking for is made by RIDGID not RIGID, you can them at
> >http://www.ridgid.com/cat73.htm Hope this helps.
> >Jim V.
>
> Amazing. Again, this list proves invaluable.
>
> As for drilling into broken-off bolts (for insertion of e-z out), I have
> heard several folks suggest using a LEFT-HANDED drill bit to do the
> drilling, with the advantage being that sometimes the broken stud will
> back
> out just due to the drilling process.
>
> However, I have never seen a set of left-hand thread drill bits! I've
> only
> looked at hardware stores, Sears, and Harbor Freight. Do only the
> high-end
> tool dealers have these?
>
> Lee M. Daniels Laboratory for Molecular Structure and Bonding
> daniels@tamu.edu Texas A&M University
> http://acs.tamu.edu/~lmd1191
>
|