> Obviously a single man asking this question !
> All of us married
> men would know the answer to this question... WFT ?
> What the F do you
> think you are putting in my oven ?
Obviously I would do it while my wife is out not
I think my wife would draw the line at powder coating,
> If you have an oven outside and that is what you
> meant then, I
> don't know the answer but I seriously doubt it would
> work from a
> 500+/- kitchen oven, I would think you would need
> higher temps to
> reduce block crud to ash. And if you do get it hot
> enough, then what
> about warping ?
I believe the self-cleaning cycle gets to 600 deg. or
I just finished an experiment: the oven needed
so I took a really cruddy bolt that had a thick layer
of gunk on the head and put it in the oven.
The self-cleaning cycle finished in 75 minutes, and
bolt had nothing left but a crust that was like dried
that easily came off under a stream of water with a
It came out much cleaner than my last experiment:
boiling a bolt
in a 50/50 mix of Simple Green and water for 30