shop-talk
[Top] [All Lists]

Re: [Shop-talk] hand tool recommendations that don't break the bank

To: shop-talk@autox.team.net
Subject: Re: [Shop-talk] hand tool recommendations that don't break the bank
From: Mark Andy <mark@sccaprepared.com>
Date: Tue, 4 Mar 2008 22:42:07 -0500 (EST)
Howdy,

On Tue, 4 Mar 2008, Eric J Russell wrote:
> For a tool that I will only use rarely, H-F is often adequate.
>
> For a tool that will get occasional or frequent use, better quality is a 
> worthwhile investment.

I've found there to be a whole range of stuff at HF... For instance, this 
is one of the better "regular" ratchets I've ever used:

http://www.harborfreightusa.com/usa/itemdisplay/displayItem.do?itemid=94586&CategoryName=&SubCategoryName=

... and I've used lots of craftsman, snap-on, mac, etc. stuff.

> I do often use a Stanley "6 in 1" screwdriver (and I keep one each 
> vehicle). It has a large & small flat blade, a large & small phillips, 
> plus two sizes of hex drive (1/4" & 5/16" I think). Its only draw back 
> is for situations where you need to reach down into a small access hole 
> - the shank is larger in diameter than a standard screwdriver.

I've got a bunch of those too, but I don't really like them for work on a 
car.  Half because the shaft is bigger and sometimes doesn't fit and half 
because its about guaranteed that it'll come apart when I'm contorted in 
some weird position.

Mark
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>