[Shop-talk] Plasma Cutter- the review

[tr3driver at ca.rr.com (Randall)]

> I'm willing to say
> that cheap chinese tools use more air, but three times as much, for
> less cutting abiity?

I could certainly be mistaken; maybe it does use only 3.5 scfm.  But I sure
wouldn't want to bet $500 on it.  Manufacturers are usually good at
presenting their products in the best possible light, and being able to run
with a small (portable) compressor would certainly be an advantage for a
unit with a handle on the top.

Maybe Moose can give us a measurement.  Start cutting with a full tank of
air and count seconds before the compressor kicks in.  If you know the
cut-in and cut-out pressures, plus the tank capacity, you can calculate
roughly how many scfm you were drawing.

-- Randall