I've used a large pair of snips. The one I used is larger than this
one in the link, but looks similar....
http://www.harborfreight.com/hand-tools/snips/7-inch-straight-pattern-snips-66592.html
It cut through the wire and rubber fine. My hands did get a work
out though. Cutting closer to the hinge worked better due to leverage.
I did not attempt to cut through the bead.
Regards,
Brian
battmain at yahoo.com
________________________________
From: "eric at megageek.com" <eric at megageek.com>
To: shop-talk at Autox.Team.Net
Sent: Sun, May 15, 2011 5:22:06 PM
Subject: [Shop-talk] Cutting tires
OK,
Does anyone have any hints for cutting tires? I want to cut the tread of
an old tire to make some pads for my backhoe's outriggers.
I don't need to cut the beard (which I know is a bear) but just the treat
face of the tire.
Thanks in advance.
Moose
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
_______________________________________________
Shop-talk at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/battmain at yahoo.com
|