I'm not sure if a wood working question is appropriate here, so let me
know if I'm stepping outside the allowed content.
I'm sure someone here has an answer however.
OK, I have a nice knife block with knife set. One of the knives was
replaced with a better one. The problem is that the new knife doesn't fit
in the slot on the block.
Does anyone know how to cut/expand one of those slots in a block of wood.
I need to go about 7" deep?
Failing any other solution, I was thinking of cutting the block in half
with a bandsaw, routing the slot, then gluing it together. This is not my
first choice however.
Thanks guys and have a happy thanksgiving!
Eric P
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|