| Subject: | [Shop-talk] Tachometers |
|---|---|
| From: | gerrybraz at cablespeed.com (Gerald Brazil) |
| Date: | Sun, 15 Jan 2012 19:07:05 -0500 |
| References: | <073a01ccd0d0$4eaac090$ec0041b0$@rr.com> |
Check e bay for a machinist's tachometer. It is a little device that looks like a large key. The "pointy" end has a little pyramid shaped tip that you push into the drill or lathe chuck. This turns a dial that you have set to 0 and then you run it for a minute and check the reading. I know that Lufkin made one. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Shop-talk] Tachometers, Gerald Brazil |
|---|---|
| Next by Date: | Re: [Shop-talk] Tachometers, Randall |
| Previous by Thread: | Re: [Shop-talk] Tachometers, Gerald Brazil |
| Next by Thread: | Re: [Shop-talk] Tachometers, Randall |
| Indexes: | [Date] [Thread] [Top] [All Lists] |