shop-talk
[Top] [All Lists]

Re: [Shop-talk] Audio receiver repair?

To: Peter Murray <peterwmurray@gmail.com>
Subject: Re: [Shop-talk] Audio receiver repair?
From: Jim Franklin <jamesf@groupwbench.org>
Date: Tue, 03 Jun 2014 08:29:34 -0400
Cc: Shop-Talk List <shop-talk@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: shop-talk@autox.team.net
References: <5385D324.4080105@groupwbench.org> <CAJ8HLP_Q+bVmr9i=w=Fes3ZiqGpVBh8pe=4AQ9M8PtaT18JiCw@mail.gmail.com>
User-agent: Mozilla/5.0 (Windows NT 6.3; WOW64; rv:24.0) Gecko/20100101 Thunderbird/24.5.0
I have looked at that page and it's great info, but I don't have enough 
electrical knowledge to know what to look for. If I found the offending 
part I could replace it, but unless there's spooge all over a cap, I'm 
not sure I'd know what "leaky" was. I'm guessing the power supply caps 
are the two big blue ones near the transformer? No leaks there....

I didn't crank up the volume, and also to Roland's point I did stop 
using the four 4 ohm speakers after blowing 3 fuses:-)

Can these types of problems be tested with a multimeter or does it 
require a scope?

jim

On 5/29/2014 11:10 AM, Peter Murray wrote:
> The lower impedance should not have caused any damage, unless you 
> cranked the volume way up and blew the amp. It sounds like you have a 
> power supply inside the amplifier that has failed. Power supplies 
> often have electrolytic capacitors for filtering and stabilization, 
> and they can dry out over time and send the supply circuit out of 
> spec. I would start there.
>
> This page may have some helpful items: 
> http://www.davidreaton.com/Model_300_repair_experiences.htm
>
> -Peter
>
>
> On Wed, May 28, 2014 at 8:14 AM, Jim Franklin <jamesf@groupwbench.org 
>
>     I have an old Advent model 300, which was a nice unit back in the
>     day. I put it in the garage and connected it to a pair of
>     bookshelf speakers and a dual-speaker subwoofer. It made no noise
>     for a few minutes and then went POP.
>
>     THEN I read the manual which said don't plug it into 4 speakers of
>     less than 8 ohms each. Mine are all 4 ohms :-\
>
>     I found a blown fuse and replaced it but now it blows right away.
>     Is there any way for someone mostly clueless about electronics to
>     diagnose what's broke? I have a basic multimeter for tools, and I
>     understand big electrons, but not the small ones...
>
>     thanks,
>     jim
>     _______________________________________________
>
>     Donate: http://www.team.net/donate.html
>     Suggested annual donation  $12.96
>     Archive: http://www.team.net/archive
>     Forums: http://www.team.net/forums
>     Unsubscribe/Manage:
>     http://autox.team.net/mailman/options/shop-talk/peterwmurray@gmail.com
_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>