The part you show is just half the valve, the rest is the seat the shown
part seals against. I can't imagine that it is not removable.
If the rest of the valve is not removable you will not be able to add your
ball valve. What brand is the heater?
Peace,
Pat
-----Original Message-----
From: Shop-talk [mailto:shop-talk-bounces@autox.team.net] On Behalf Of Scott
Hall
Sent: Sunday, September 13, 2015 9:13 AM
To: Shop-talk@autox.team.net
Subject: [Shop-talk] Water heater drain help
Guys,
Got new water heater for house. Want to replace existing drain arrangement
with ball valve for better draining.
The fitting into the tank I think is probably not replaceable. But I could
replace the plastic plug and screw a fitting/ball valve into it. It looks
like this:
http://imgur.com/wn4DPQg
But I'm not sure what that thread is. It's not NPT--it seems to be about
twice as coarse as NPT.
I tried a 1/2" NPT spigot iftting I has here and it screws in, but it looks
like it might be cutting its own threads into the fitting on the tank, which
I think is Bad.
Anyone familiar with what that thread might be?
The plug's plastic so it won't rust, but it looks like it's just asking to
have those tiny holes clogs, or for the whole plastic plug to embrittle and
break. A nice ball valve with a big handle on it would be preferable.
Scott
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/shop-talk/pat@hornesystemstx.com
_______________________________________________
Shop-talk@autox.team.net
Archive: http://www.team.net/archive
|