| To: | Shop Talk <shop-talk@autox.team.net> definitions=2020-01-17_04:, , signatures=0 malwarescore=0 phishscore=0 bulkscore=0 spamscore=0 clxscore=1015 mlxscore=0 mlxlogscore=559 adultscore=0 classifier=spam adjust=0 reason=mlx scancount=1 engine=8.0.1-1908290000 definitions=main-2001170123 |
|---|---|
| Subject: | [Shop-talk] Modern throw out bearings |
| From: | Robert Nogueirao via Shop-talk <shop-talk@autox.team.net> |
| Date: | Fri, 17 Jan 2020 10:00:35 -0600 |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | shop-talk@autox.team.net |
Folks forgive me for asking a question which is not shop related but I just canâ??t seem to get a straight answer anywhere else. Are modern throwout bearings ( ball bearing not carbon block) designed to remain in no load contact with the pressure plate, that is, the bearing is always spinning? Just to b e clear, I too was taught to be sure to always allow clearance between the bearing and plate but does this apply to non adjustable direct action hydraulic clutches of today? Bob Nogueira _______________________________________________ Shop-talk@autox.team.net Donate: http://www.team.net/donate.html Suggested annual donation $12.96 Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive Unsubscribe/Manage: http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Shop-talk] battery charging rates, DAVID MASSEY via Shop-talk |
|---|---|
| Next by Date: | Re: [Shop-talk] Modern throw out bearings, Jack Brooks via Shop-talk |
| Previous by Thread: | [Shop-talk] battery charging rates, john niolon via Shop-talk |
| Next by Thread: | Re: [Shop-talk] Modern throw out bearings, Jack Brooks via Shop-talk |
| Indexes: | [Date] [Thread] [Top] [All Lists] |