No. The EGR port is only active during certain throttle plate openings.
You can get a port from Home depot probably to thread into the correct
vacuum advance port.
----- Original Message -----
From: Mostrom, Paul <Mostrom.Paul@principal.com>
To: 'rhill' <email@example.com>; <firstname.lastname@example.org>
Sent: Thursday, August 05, 1999 6:50 AM
Subject: RE: ZS 150CD vacuum advance....
> I believe that earlier this week there was a similar thread that stated
> there was a 'T' installed in the EGR valve vacuum line that went to the
> Can't prove it from my '77 since I have a Weber DGV and header
> Paul Mostrom
> '77 Spitfire 1500
> '80 Ford F-100 (Triumph Support Vehicle)
> 'Black holes, where God divided by zero......'
> -----Original Message-----
> From: rhill [mailto:email@example.com]
> Sent: Thursday, August 05, 1999 8:15 AM
> To: firstname.lastname@example.org
> Subject: ZS 150CD vacuum advance....
> Just received a rebuilt Z-S 150CD and I am having the following problem:
> There isn't a connection for the vacuum advance. There should be a
> connection on the bottom of the carb for this (there is, however, a
> brass plug where the connection should be).
> This leads to the following question: Can the vacuum advance be
> connected to the same port as the EGR valve? (the top port?), or should
> I just return the carb to the vendor?
> Thanking you in advance,
> Bob Hill