Hi Tim
I wanted to ensure a good seal on the intake manifold for my Weber DGV so I used
the silicon sealant with copper. It has high temp characteristics. I have had no
problems with it, either sealing or otherwise. It also works fine on the
exhaust!
Vic Whitmore
76 Spitfire
Thornhill, Ontario
"T. .R. Dafforn" wrote:
>
> Hi all,
> Just about to instal a new manifold to head gasket on a 1500 to sort out
> an vacuum leak..
> Anyone any helpful suggestions?
> ie. Is it worth using any gasket compound?
> Cheers
> Tim
> PS I am fitting a twin weber manifold, 2 piece, one for the front car,
> and one for the back...
> I am finding aligning them a bit hard, but I noticed a small hole in the
> face of the head, in between the two inlet ports, that matches one on
> the inlet manifolds, what are these for, and can they be used to help
> alignment?
>
> --
> Tim Dafforn
http://www.vicwhit.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|