I have a flat place on my front hub that is less than 1/64" wide and 3/4"
long. I can't get a piece of the green tape to stick very well.
Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1972/1978 Spit Six Project car "Joseph"
-----Original Message-----
From: FRED E THOMAS [mailto:frede.thomas2@verizon.net]
Sent: Thursday, July 23, 2009 4:05 PM
To: Daniel Parrott; 'Spitfire list'
Subject: Re: [Spits] Powder Coat Question
Daniel, I have only used the =caps & plugs=, never a problem FT
============================================================================
========
----- Original Message -----
From: "Daniel Parrott" <parrotthead01@comcast.net>
To: "'Spitfire list'" <spitfires@autox.team.net>
Sent: Thursday, July 23, 2009 3:12 PM
Subject: [Spits] Powder Coat Question
> Has anyone ever use the tube silicon sealant to protect sensitive areas
> when
> powder coating? I figured since the plugs and caps are made with cured
> silicone, that some hardened silicone will also provide protection, and
> still be easy to remove. Any ideas?
>
>
>
> Dan Parrott
>
> Savannah, Ga
>
> 1980 Triumph Spitfire "PJ"
>
> 1972/1978 Spit Six Project car "Joseph"
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Spitfires@autox.team.net
> http://autox.team.net/mailman/listinfo/spitfires
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|