spridgets
[Top] [All Lists]

Re: FW: PPG Deltron Paint

To: spridgets@Autox.Team.Net, Bert Kleinschmidt <kleinschmidt@earthlink.net>
Subject: Re: FW: PPG Deltron Paint
From: Leo Speichinger <ldsp@flash.net>
Date: Mon, 27 Oct 1997 18:06:09 -0600
Organization: ABC Generic Company Inc.
References: <01BCE271.16D6D0D0@pool017-max1.so-ca-us.dialup.earthlink.net>
Reply-to: Leo Speichinger <ldsp@flash.net>
Sender: owner-spridgets@Autox.Team.Net
Bert Kleinschmidt wrote:
> 
> Leo Speichinger wrote:
> >
> >Any time when taking metal down to bare finish as you do by blasting
> >always use a two part epoxy etching primer and you will not have that
> >problem. A good brand is Sherwin Williams E2-G980 etching filler. It has
> >to be mixed 1 to 1 ratio with R7-K982 which is the activator. Once dry
> >it is extremly hard to bead blast off as it attaches and seals to the
> >micro ridges of the blasted metal.
> >
> >If you have any questions
> >ldsp@flash.net
> 
> I am in the process of stripping most of a Sprite down to bare steel.
> I had planned to etch the metal before priming (using a metal etch
> product which contains phosphoric acid).  Will this serve the same
> purpose, or will I still need a special primer?
> 
> Bert.
An etching primer bonds and seals where as a regular primer does'nt.
I'll get an info sheet scanned and send it to you as it can answer
better than I can as I'm not good at explaining what I mean to say.
That made a lot of sense !!huh

<Prev in Thread] Current Thread [Next in Thread>