Daryl
You may get it out with an internal pipe wrench. An internal pipe wrench is
the oppisite of a stud remover, it has a wheel that expands when you turn
it. I used one to get out the remains of the speedo cable housing that I
broke off the 210 tranny.
Larry
-----Original Message-----
From: Daryl May <mayfam@sprynet.com>
To: spridgets@Autox.Team.Net <spridgets@Autox.Team.Net>
Date: Saturday, April 18, 1998 5:43 PM
Subject: Temperature Probe HOUSING
>Need guidance, please, on the HOUSING on my 1275 cylinder head that holds
>the temperature sensor.
>
>Stripping the head for a rebuild, I foolishly tried to unscrew the housing,
>which snapped off.
>
>1. Is it a force-fit, or a threaded part, or what?
>
>2. If a force-fit, I'll need to drill out the neck trapped in the head.
>Then do I just hammer the new one in?
>
>3. If a force-fit, what would you suggest to stop the replacement part
>from leaking?
>
>Thanks,
>
>Daryl
>
>
|