spridgets
[Top] [All Lists]

Slave Cylinder Push Rod

To: spridgets@Autox.Team.Net
Subject: Slave Cylinder Push Rod
From: Bob Frato <bobfrato@bright.net>
Date: Fri, 19 Jun 1998 21:42:05 -0400
Reply-to: Bob Frato <bobfrato@bright.net>
Sender: owner-spridgets@Autox.Team.Net
When I got my car(59' Bugeye) it had a 3/4" master cylinder.  I've gone
back to the original 7/8" bore master cylinder.  My question is, the push
rod on the car was one for a 1275 (3/4" bore), when going back to the 7/8"
MC should I use the longer 1275 push rod or the shorter 7/8" MC push rod.
Or is this depended on other configurations.  

Thanks for your Help

Bob Frato
AN5L17601


<Prev in Thread] Current Thread [Next in Thread>
  • Slave Cylinder Push Rod, Bob Frato <=