spridgets
[Top] [All Lists]

RE: alignment & jig data?

To: "'Evangelos G. Makris'" <emakris@hol.gr>
Subject: RE: alignment & jig data?
From: Daniel Thompson <dthompson@gbc.ca>
Date: Fri, 2 Oct 1998 14:24:56 -0400
Cc: "'spridgets@autox.team.net'" <spridgets@Autox.Team.Net>
Organization: GBC Asset Management Inc
Reply-to: Daniel Thompson <dthompson@gbc.ca>
Sender: owner-spridgets@Autox.Team.Net
I should think that would be a very difficult undertaking, and expensive!

You could try to do what Wheeler & Davis (and others) have done. Buy a 
stripped version of the Heritage shell and start modifying from there.

Daniel

-----Original Message-----
From:   Evangelos G. Makris [SMTP:emakris@hol.gr]
Sent:   Friday, October 02, 1998 2:19 PM
To:     spridgets@autox.team.net
Subject:        alignment & jig data?

Is there a place in the web (or elsewhere) where one can
obtain alignment data for the Spridgets themselves or
their jigs?

I have this zany idea about building another one myself
from what bits I can unearth here and there...

Regards

Evangelos Makris



<Prev in Thread] Current Thread [Next in Thread>