Phil
If you don't find any I could probably let you have a pair of the 3" ones
that you could shorten.
Larry Miller
-----Original Message-----
From: Phil Vanner <pvanner@pclink.com>
To: 'Larry and Sandi Miller' <millerls@email.msn.com>; Spridgets
<spridgets@Autox.Team.Net>
Date: 17 November, 1998 9:49 AM
Subject: RE: MC Push Rods
>Hmm, in that case does anybody have a set of 2.5 inch pushrods for a 3/4
>bore MC they can spare? If they're ovalled out, I'll fill them with weld
>and re-drill them. I was about to switch MC's and was going with the
>consensus that they were the same.
>
>One of these days I'm really going to get this disc brake conversion in, I
>really am.
>
>Phil Vanner
>Mk1 Midget
>
>-----Original Message-----
>From: Larry and Sandi Miller [SMTP:millerls@email.msn.com]
>Sent: Tuesday, November 17, 1998 10:05 AM
>To: Spridgets
>Subject: MC Push Rods
>
>This has come up before and I seem to remember that the consensus was that
>the rods for the 3/4 and the 7/8 MC were the same length. I was sorting out
>a box of brake parts containing four Sprite master cylinders and all of
>their bits and pieces, three 7/8's and one 3/4 cylinder. Four sets of push
>rods, three sets 3'' long and one set 2 1/2' inch long. This would seem to
>indicate that the 3/4 cylinder has shorter rods.
>
>Anyone have either type laying around where you could measure the rods. I
>measured just the smooth portion of the rod, not the wrench fitting and the
>threads.
>
>Comments appreciated.
>
>Larry Miller (bugiiis@yahoo.com or millerls@msn.com)
>59 Bugeye (Starting to look like a Bugeye)
>59 Bugeye "BUGIIIS" (Undergoing a body transplant)
>78 911 SC (Faster than a Bugeye but not as much fun)
>Home Page http://members.xoom.com/bugiiis
>
>
>
>
>
|