| To: | Phil Vanner <pvanner@pclink.com> |
|---|---|
| Subject: | Re: interchangeability of rear end parts |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Fri, 11 Dec 1998 17:34:03 -0500 |
| Cc: | "'David Christman'" <dpc@ai.mit.edu>, "spridgets@autox.team.net" <spridgets@Autox.Team.Net> |
| Organization: | Positive Earth Drivers Club |
| References: | <01BE2502.FC0C9D40@pcni-200> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@Autox.Team.Net |
Phil Vanner wrote: > > I'll take a crack at this one. Whatever I get wrong will be promptly > corrected. > Phil You did pretty good. Not that anything was wrong but when swapping diffs sometimes you end up with 2 filler plugs which is no big deal and sometimes you end up with NO filler plug in which case you can fill the diff via the axle hole. Basically only the axle housings are different. Early housings (1/4 leafs) have the filler on the housing, later (1/2) leafs hav it on the diff. -- Frank Clarici Toms River, NJ Lots of LBCs http://www.exit109.com/~spritenut |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: PAECO, Ron Madurski |
|---|---|
| Next by Date: | Clutch slave, J. Morris |
| Previous by Thread: | RE: interchangeability of rear end parts, Phil Vanner |
| Next by Thread: | Re: interchangeability of rear end parts, Bkitterer |
| Indexes: | [Date] [Thread] [Top] [All Lists] |