Re: Half shaft , hub, gasket, etc.

["Peter C." <nosimport@mailbag.com>]

And........ (all together now)..... don't forget to verify the axle housing
breather is clean and working.
A simple thing often overlooked and often clogged by over zealous
undercoaters. It's easier to stop leaks that aren't pressurized.  My  US$.02
Peter C

At 03:26 PM 2/17/99 , Dave wrote:
>I'd say try to pin point the leak.
>It should be obvious, after removal of the brake drum, if the leak is coming
>from the rear (wheel bearing) seal. If it's dry back there, then just do the
>gasket and *new* o-ring
>and keep your fingers crossed. If it still leaks, well ....
>you know what you have to do.
>
>good luck
>
>d