Charles,
You will need to drain at least a small amount of coolant if you don't want
coolant to spill down the front of the engine when the housing is removed.
It's been a long time since I've driven in the rain, or with the top on for
that matter. Though I own two hardtops, a softop, and tonneau, none of them
will fit over the rollbar of my current driver. That won't be the case on
my other two... when they are drivable again.
At 8:00 AM -0400 8/26/99, Charles D. Sorkin wrote:
>Now that makes the most sense, as my question arose from the fact that it
>looks physically impossible to just lift up the elbow joint, the way I
>expected. Since it looks like rain tonight in New Jersey, I'll probably
>tackle the issue now. One important question though... should I drain any
>coolant? The fixture looks like its at the top of the system, and I would
>be surprised if any fluid is sitting up there.
>
>Secondly, (off subject) several folks on this list use their Mark I - Mark
>III Midgets as daily drivers. How does one keep the interior dry in a
>rainstorm? One the one occaison when a thunderstorm came up in my '74 Mark
>III, I noticed water coming in between the top of the side windows and the
>canvas top, and between the windshield and canvas top. How do you folks
>cope with this problem, short of investing in a hardtop?
>
>
>-----Original Message-----
>From: Gerard Chateauvieux <pixelsmith@gerardsgarage.com>
>To: Charles D. Sorkin <cdsorkin@ix.netcom.com>
>Date: Wednesday, August 25, 1999 10:25 PM
>Subject: Re: The truth about 'stats
>
>
>>Charles,
>>
>>Later model Spridgets had a bolt hole like the one you describe for smog
>>air pump. Maybe your smog equipment is removed or perhaps someone swapped
>>that part from a different model.
>>
>>Gerard
>>
>>>Well, I ran out of time over the weekend, but the Thermostat issue has
>been
>>>bugging me because my "elbow joint" (I've actually thought it was called a
>>>gooseneck) just doesn't look like the one in the Hayne's book, as there
>>>seems to be a bolt that runs parallel to the ground which would prevent
>the
>>>housing from being lifted straight up. Perhaps the PO modified the
>colling
>>>system somehow?
>>>
>>>Anyway, I will experiment further. In any case, the Thermostat is the 165
>>>degree (I guess its about time for the 180 degree, at this point) which I
>>>ordered from Northwest Import. It was packaged by Unipart (I think), made
>>>in the UK. Does that imply high quality?
>>>
>>>Regards,
>>>
>>>
>>>Charles
>>>'74 Midget
>>>cdsorkin@ix.netcom.com
>>>Bloomfield, NJ
>>
>>
>>G G Gerard Chateauvieux
>> E A
>> R R pixelsmith@gerardsgarage.com
>> A A
>> R G Pixelsmith on Duty
>> D E
>> S http://www.gerardsgarage.com
>>
>>
>>
>>
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|