I don't see one. There was a nylock nut.
-----Original Message-----
From Glen Byrns <grbyrns at ucdavis.edu>
To: Robert Duquette <RobertDuquette@Sympatico.ca>
Cc: spridgets@autox.team.net <spridgets@autox.team.net>
Date: February 10, 2000 6:47 PM
Subject: Re: trunnion link
>Robert,
>
>Perhaps one of the very thin spacer washers is still in place? They are a
>close fit over the threads and may bind as you lift the upper link up to
the
>threads.
> Regards, Glen Byrns
>
>
>> I'm sure this is a silly question somehow, but is there a reason why a
>> trunnion link that rotates freely and moves freely up and down, about 1/8
>of
>> an inch, will not come off. ( For the SAs, yes the nut has been
>removed. )
>> It seems to bind when it gets to the threads.
>>
>> Bigger hammer?
>>
>> Robert Duquette
>> Ottawa ON Canada
>> http://www3.sympatico.ca/robertduquette
>> RobertDuquette@Sympatico.ca
>> '65 RHD BRG Sprite
>>
>
>
|