I'd go with 2 O2 sensors; switched of course.
"Graziano, Michael" wrote:
> All,
>
> I'm once again contemplating installing an air/fuel ratio gauge. I know
> that install should be relatively easy, but I'm not sure on the location of
> the sensor. With a manifold, it would be easy. But where would I install
> the sensor with 4-2-1 headers? I would think all the way down by the
> collector for the 2-1 part would be too far along in the exhaust to be of
> any use.
>
> Any ideas?
>
> Mike
> '78 Midget (Twin HS4's and 4-2-1 headers)
>
> This message is for the named person's use only. It may contain
> confidential, proprietary or legally privileged information. No
> confidentiality or privilege is waived or lost by any mistransmission.
> If you receive this message in error, please immediately delete it and all
> copies of it from your system, destroy any hard copies of it and notify the
> sender. You must not, directly or indirectly, use, disclose, distribute,
> print, or copy any part of this message if you are not the intended
> recipient. CREDIT SUISSE GROUP and each of its subsidiaries each reserve
> the right to monitor all e-mail communications through its networks. Any
> views expressed in this message are those of the individual sender, except
> where the message states otherwise and the sender is authorised to state
> them to be the views of any such entity.
> Unless otherwise stated, any pricing information given in this message is
> indicative only, is subject to change and does not constitute an offer to
> deal at any price quoted.
> Any reference to the terms of executed transactions should be treated as
> preliminary only and subject to our formal written confirmation.
|