spridgets
[Top] [All Lists]

Re: Big Brake steering arms.

To: John Holliday <fprodget@yahoo.com>
Subject: Re: Big Brake steering arms.
Date: Wed, 04 Oct 2000 21:56:30 -0700
Cc: drewzer@pacbell.net, Daniel1312@aol.com, spridgets@autox.team.net
References: <20001004123019.21729.qmail@web3803.mail.yahoo.com>
Thanks for the reply John,
I'm piecing this upgrade together, but I did get the Spitfire hub
adapters from Mini-Mania.
At any rate, after sizing up the situation a little more I'm going to
try an eighth inch spacer for the arms to start, I'll go as thick as a
quarter inch but anything over that I'm afraid will shorten the bolt by
too much, and if that doesn't work then I'll cut the rotors... I really
don't want to try bending the arms.
Thanks again,
-Drew in San Jose.

John Holliday wrote:

> Drew,
> My big brake kit from Winner's circle only needed very
> little cut off the outer corner of the rotor. So
> slight that it no way affected the pad contact area.
>
> John Holliday
> 67 fprod street sprite


<Prev in Thread] Current Thread [Next in Thread>